2MT Direct Collets – Metric

2MT Direct Collets – Metric

Quality 2 morse taper finger collets in a range of different metric sizes.

• Tapped 3/8″ Whitworth for drawbar.

• Suitable for a range of different Warco milling machines.

• Collets can be purchased individually and are therefore very affordable.

Sizes available

• 2MT 2mm (Item No. 2025)

• 2MT 3mm (Item No. 2026

• 2MT 5mm (Item No. 2027)

• 2MT 6mm (Item No. 2028)

• 2MT 10mm (Item No. 2029)

• 2MT 11mm (Item No. 2030)

• 2MT 12mm (Item No. 2031)

About direct collets

• These collets are an alternative to the collet chuck system.

• Each direct collet is held by the machine drawbar.

• As the collet is drawn into the quill it firmly clamps around the end mill / slot drill shank.

• Both plain and threaded shank cutters can be used.

• Direct collets do not overhang which allows maximum capacity between the spindle and table.

Also available

• 2MT collets in imperial sizes